Jan 10th, 2004, 20:04 | #1 |
Junior Member
注册日期: Jul 2004
帖子: 26
|
我的车(94 Grand Am)前两天自己更换turn signal flasher,换好后突然注意到以下几个故障: 1. ABS 仪表灯常亮, ABS 不工作 2. 收音机不工作(有电流声),时间显示也没有 3. 引擎不工作时,无论车门关闭与否,钥匙拔出与否,都是叮叮告警声,车内灯常亮(就是平常钥匙没拔出,打开车门时告警一样的状态),痛苦异常,不得以找到并拔掉车门告警器的连接头. 检查fuse都正常,我百思不得其解,请高手相助! 另外象这种电路问题,是不是到dealer那儿修比较好?各位可有建议,先行谢过! |
|
Jan 11th, 2004, 15:50 | 只看该作者 #7 |
Junior Member
注册日期: Jul 2004
帖子: 26
声望: 82
|
断过电.这是电路图, from:http://aarc.epnet.com/ads/index.cfm<BLOCKQUOTE class="ip-ubbcode-quote"><font size="-1">quote:</font><HR>Originally posted by moto人: 他没说断过电呀! 应该是线路有虚接或接地问题。有线路图吗?贴出来看看<HR></BLOCKQUOTE> |
|
Jan 18th, 2004, 07:07 | 只看该作者 #9 |
Senior Member
注册日期: Jul 2004
帖子: 964
积分:6
精华:3
声望: 301
|
不管你是否愿意接受,多数车行按时收费,这也许是有些车行不愿意查电路的原因之一吧。朋友说过一个极端的例子,有车跑电,查不出原因,整车大线都动了,最后花费$1400查出有一个硬币在某处导致偶尔跑电。 自己找时间慢慢查吧。 <BLOCKQUOTE class="ip-ubbcode-quote"><font size="-1">quote:</font><HR>Originally posted by togeorge: 今天早上咬咬牙,把车送到dealer那儿去检测,说是要一个小时,收费$94,原以为忍痛花钱把问题解决就好了,谁想到一个小时后告诉我没查出来,问我是否继续进行下去(当然继续收费), 我赶紧叫停,面对一个没有任何检测诊断结果,却仍要全额收诊断费的单子, 我和他们干了一仗,他们这钱也太容易赚了, 我faint.见识了dealer的水平,我还是开回来再想办法吧.<HR></BLOCKQUOTE> |
|
Jan 18th, 2004, 21:31 | 只看该作者 #12 |
Junior Member
注册日期: Jul 2004
帖子: 26
声望: 82
|
可惜我在Calgary. 整个过程是这样的:原先电器正常,只是里程表个位百位一起跳,还有速度表慢10公里/小时.我就更换了一个旧的仪表总成,然后就发现3个月不到,转向灯的flasher闪的很慢以至完全不闪了.更换了好几次,烦了,就想看看是不是仪表总成的接头有没有问题,由于是晚上路灯下,也没想到断电,当时发动机工作,车内灯打开,将仪表总成拆了一下,看看接口没问题,马上又装好,就出现上述问题了,后来断电后重新接上实验,问题依旧. 我比较同意老许,有门!兄弟的分析. 不过实在是匪夷所思,磁带机可以放音,收音机不行.谢谢各位,实在不行就这样吧,以后刹车"手动"防抱死就行了. |
|
Jan 19th, 2004, 21:25 | 只看该作者 #13 |
Senior Member
注册日期: Jul 2004
帖子: 684
声望: 15859
|
希望下面的信息有帮助 THEFTLOCK is designed to discourage theft of your radio. It works by using a secret code to disable all radio functions whenever battery power is removed. The THEFTLOCK feature for the radio may be used or ignored. If ignored, the system plays normally and the radio is not protected by the feature. If THEFTLOCK is activated, your radio will not operate if stolen. When THEFTLOCK is activated, the radio will display LOC to indicate a locked condition anytime battery power is removed. If your battery loses power for any reason, you must unlock the radio with the secret code before it will operate. Activating the Theft-Deterrent Feature The instructions which follow explain how to enter your secret code to activate the THEFTLOCK system. It is recommended that you read through all nine steps before starting the procedure. If you allow more than 15 seconds to elapse between any steps, the radio automatically reverts to time and you must start the procedure over at Step 4. 1. Write down any three or four-digit number from 000 to 1999 and keep it in a safe place separate from the vehicle. 2. Turn the ignition to ACC or ON. 3. Turn the radio off. 4. Press the 1 and 4 buttons together. Hold them down until --- shows on the display. Next you will use the secret code number which you have written down. 5. Press MIN and 000 will appear on the display. 6. Press MIN again to make the last two digits agree with your code. 7. Press HR to make the first one or two digits agree with your code. 8. Press AM-FM after you have confirmed that the code matches the secret code you have written down. The display will show REP to let you know that you need to repeat Steps 5 through 7 to confirm your secret code. 9. Press AM-FM and this time the display will show SEC to let you know that your radio is secure. Note that with the ignition off, the THEFTLOCK LED indicator will flash, indicating a secured radio. |
|
Jan 19th, 2004, 21:51 | 只看该作者 #14 |
Senior Member
注册日期: Jul 2004
帖子: 684
声望: 15859
|
Unlocking the Theft-Deterrent Feature After a Power Loss Enter your secret code as follows; pause no more than 15 seconds between steps: 1. Turn the ignition on. LOC will appear on the display. 2. Press MIN and 000 will appear on the display. 3. Press MIN again to make the last two digits agree with your code. 4. Press HR to make the first one or two digits agree with your code. 5. Press AM-FM after you have confirmed that the code matches the secret code you have written down. The display will show SEC, indicating the radio is now operable and secure. If you enter the wrong code eight times, INOP will appear on the display. You will have to wait an hour with the ignition on before you can try again. When you try again, you will only have three more chances (eight tries per chance) to enter the correct code before INOP appears. If you lose or forget your code, contact your dealer. Disabling the Theft-Deterrent Feature Enter your secret code as follows; pause no more than 15 seconds between steps: 1. Turn the ignition to ACC or ON. 2. Turn the radio off. 3. Press the 1 and 4 buttons together. Hold them down until SEC shows on the display. 4. Press MIN and 000 will appear on the display. 5. Press MIN again to make the last two digits agree with your code. 6. Press HR to make the first one or two digits agree with your code. 7. Press AM-FM after you have confirmed that the code matches the secret code you have written down. The display will show ---, indicating that the radio is no longer secured. If the code entered is incorrect, SEC will appear on the display. The radio will remain secured until the correct code is entered. When battery power is removed and later applied to a secured radio, the radio won’t turn on and LOC will appear on the display. To unlock a secured radio, see “Unlocking the Theft-Deterrent Feature After a Power Loss” earlier in this section. |
|
Jan 21st, 2004, 14:01 | 只看该作者 #18 |
Senior Member
注册日期: Jul 2004
帖子: 684
声望: 15859
|
Power Door Locks With the power door locks, you can unlock or lock all of the doors of your vehicle from the driver or front passenger door lock switch. Push the top of the switch to unlock all of the doors. Push the bottom of the switch to lock all the doors. Automatic Door Locks Just close your doors and turn on the ignition. All of the doors will lock when you move your shift lever out of PARK (P) to REVERSE (R) for an automatic transaxle. All of the doors will lock when the vehicle speed is greater than 5 mph (8 km/h) for a manual transaxle. If someone needs to get out while the vehicle is running, have that person use the door lock. When the door is closed again, it will lock automatically when the vehicle reaches about 5 mph (8 km/h). All doors will automatically unlock when the shift lever is moved to PARK (P) and when the key is turned to OFF. Programmable Automatic Door Locks Programmable Automatic Door Locks is a standard feature intended to provide enhanced security and convenience by automatically locking and unlocking the doors. One of four operating modes may be selected and programmed by the driver for an automatic transaxle: Mode 1: All doors automatically lock when the transaxle is shifted out of PARK (P). The doors will remain locked unless manually unlocked or the lock button is pressed. All doors will unlock when the transaxle is shifted into PARK (P) and the key is turned to OFF. Mode 2: This mode is only available with the remote keyless entry transmitter. All doors automatically lock when the transaxle is shifted out of PARK (P). Automatic driver’s door only unlock when the transaxle is shifted into PARK(P) and the key is turned to OFF. Mode 3: All doors automatically lock when the transaxle is shifted out of PARK (P). No automatic door unlock. Mode 4: No automatic door lock or unlock. |
|
Jan 21st, 2004, 14:02 | 只看该作者 #19 |
Senior Member
注册日期: Jul 2004
帖子: 684
声望: 15859
|
One of the four operating modes may be selected and programmed by the driver for a manual transaxle: Mode 1: All doors automatically lock when the vehicle speed is greater than 5 mph (8 km/h). The doors will remain locked unless manually unlocked or the lock button is pressed. All doors will unlock when the transaxle is shifted into REVERSE (R) and the key is turned to OFF. Mode 2: This mode is only available with the remote keyless entry transmitter. All doors automatically lock when the vehicle speed is greater than 5 mph (8 km/h). Automatic driver’s door only unlock when the transaxle is shifted into REVERSE (R) and the key is turned to OFF. Mode 3: All doors automatically lock when the vehicle speed is greater than 5 mph (8 km/h). No automatic door unlock. Mode 4: No automatic door lock or unlock. The Programmable Automatic Door Locks will be in operating mode 1 when the vehicle is shipped from the factory. Disconnecting the vehicle battery for up to one year will not change the programmed mode of the Programmable Automatic Door Locks. The operating mode of the Programmable Automatic Door Locks will be changed when the driver performs the following sequence with the doors closed and the vehicle’s ignition key to ON. To change the mode: 1. Press and hold LOCK on the power door lock switch for 10 seconds. Release the switch when you hear the chime. 2. Count the number of chimes you hear. The number of chimes tells you which mode your vehicle is in. You can change the mode by pressing and holding LOCK on the power door lock switch (two chimes for mode 2, three chimes for mode 3 and four chimes for mode 4). 3. Repeat Step 1 until you hear the number of chimes that matches the mode you want. The mode you selected is now set. |
|